Sample config for e500v2 toolchain

On Tuesday 14 October 2008 17:05:31 Nate Case wrote:
> This is a sample config file for Freescale e500v2 processors (e.g.,
> MPC8548, MPC8572). It uses eglibc (for e500/SPE patches) and a recent
> gcc (4.3.1, for e500v2 DPFP support) and will generate appropriate
> dual-precision floating point instructions by default.
>
> Note: If building a Linux kernel with this toolchain, you will want to
> make sure -mno-spe AND -mspe=no are passed to gcc to prevent SPE
> ABI/instructions from getting into the kernel (which is currently
> unsupported). At this time, the kernel build system only passes
> -mno-spe by default (this should be fixed soon hopefully).
>
> A binutils snapshot is used to fix a bug present in 2.18 preventing
> U-Boot from being compiled (CodeSourcery issue #2297: internal.h
> (ELF_IS_SECTION_IN_SEGMENT): Adjust to cope with segments at the end of
> memory).

Obsoletes the powerpc-unknown-linux-gnuspe sample, so remove it.

/trunk/samples/powerpc-e500v2-linux-gnuspe/crosstool.config | 307 307 0 0 +++++++++++++++++++
1 file changed, 307 insertions(+)

 # GMP and MPFR libraries config options

 menu "GMP and MPFR"

 config GMP_MPFR

     bool

     prompt "GMP and MPFR"

     help

       Recent gcc needs both GMP and MPFR to build some frontends.

       Say 'Y' here if you want to build those two libraries specifically

       for crosstool-NG.

       The packages that can use GMP and MPFR are:

         - binutils

         - gcc

         - gdb

 config GMP_MPFR_TARGET

     bool

     prompt "Build libraries for the target"

     depends on GMP_MPFR

     depends on ! BARE_METAL

     default n

     help

       Also build libraries for the target. This can be usefull if you want

       to later build a compiler that will run on the target, or if you want

       to run gdb natively on the target.

 if GMP_MPFR

 source config/gmp_mpfr/gmp.in

 source config/gmp_mpfr/mpfr.in

 endif

 endmenu